| Remove damaged screw heads and extract free spinning screws with GRABIT®!
No other screw extractor removes damaged heads AND extracts free spinning
screws! How It's Used Operating Instructions - Insert GRABIT directly into drill or quick-change chuck-Burnishing end
is showing
- Set drill for reverse (counterclockwise).
- Place Burnishing end of tool into damaged screw, slowly clean inside
screw head until smooth. Note: Burnishing tool end in not to be used to
drill a hole.
Removing - Remove Burnishing end from chuck, flip tool, replace into drill
chuck-Remover end now showing.
- Maintain reverse setting (counterclockwise).
- Place Remover end of tool into now smooth screw head.
- Apply firm downward pressure, drill at slow speed. Apply lowest level of
power to the hand drill.
- Remover end of GRABIT will thread into screw head and remove.
 Reusable
The GRABIT Damaged Screw Remover is reusable. Clean chips off toll and lubricate
with oil after use. Warning
Always wear safety glasses when operating or near power tools. Cutting tools may
shatter when broken. GRABIT is available individually
Part No. 8002P - removes #6-#10 screws
Part No. 8003P - removes #12-#14 screws
Part No. 820P - 2 piece kit  |