Clicon - TomTom - Go 520/ 720/ 920 - Fixed Install Holder, Molex
System with Lock
NO HOLES INSTALLATION:
How to attach a holder to a dashmount
1. Loosen the screw in the centre of the holder
so you can remove the tilt swivel attaching
plate on the back of the holder
2. Place the attaching plate in the desired
position on the dashmount. Screw the attaching
plate into place with the enclosed screws
3. Place the holder over the attaching plate,
aligning the attachment screw in the holder with
the attaching plate. Screw the holder onto the
attaching plate
4. The holder is in place. PLEASE NOTE: Do not
over tighten the attachment screw
A GPS Holder designed to hold the device firmly
in an up-right position.
With the built-in Tilt Swivel the holder can be
adjusted to avoid light reflection on the screen.
Locks the device in to the holder so that it can not
be easily removed
The
device can be easily removed and stored away or
taken with you.
The
power cable has an in-line 12/24 volts power
regulator that allows connection directly to the
vehicle’s power system. Output 5 Volts 2 amps.
The
assembly can also provide power & charge to a range
of Blue Tooth GPS receivers or a second device.
Manufactured in ABS Plastic.
One
Year Warranty
Molex adapter
cables
945070
Adaptor Cable, Molex 4 Pin to DC,4mm
945071
Adaptor Cable, Molex 4 Pin to RJ11
945072
Adaptor Cable, Molex 4 Pin to Mini DIN 6 Pin Male
945073
Adaptor Cable, Molex 4 Pin to DC, 3.5 mm
945074
Adaptor Cable, Molex 4 Pin to Mini USB
945075
Adaptor Cable, Molex 4 Pin to PS2
945076
Adaptor Cable, Molex 4 Pin to Mini DIN 6 Pin Female
945077
Adaptor Cable, Molex 4 Pin to RJ45
945078
Adaptor Cable, Molex 4 Pin to RX/TX/Ground with open
end wires
**PLEASE ADVISE IN SHIPPING NOTES WHICH MOLEX
CABLE IS REQUIRED**
Trademarks are owned by the respective manufacturers. Copyright
1995-2008 C1 Group.
For information or assistance with this site, contact C1 Group
Helpdesk EAOE
Links: Technology at
Play