ClicOn - Nokia E51 - Fixed Install Holder, Molex System
NO HOLES INSTALLATION:
How to attach a holder to a dashmount
1. Loosen the screw in the centre of the holder
so you can remove the tilt swivel attaching
plate on the back of the holder
2. Place the attaching plate in the desired
position on the dashmount. Screw the attaching
plate into place with the enclosed screws
3. Place the holder over the attaching plate,
aligning the attachment screw in the holder with
the attaching plate. Screw the holder onto the
attaching plate
4. The holder is in place. PLEASE NOTE: Do not
over tighten the attachment screw
A
PDA/Mobile Holder designed to hold the device firmly in
an up-right position.
With
the built-in Tilt Swivel the holder can be adjusted
to avoid light reflection on the screen.
The
device can be easily removed and stored away or
taken with you.
The
power cable has an in-line 12/24 volts power
regulator that allows connection directly to the
vehicle’s power system. Output 5 Volts 2 amps.
The
assembly can also provide power & charge to a range
of Blue Tooth GPS receivers or a second device.
Manufactured in ABS Plastic.
One
Year Warranty
Molex
adapter cables
945070 Adaptor Cable, Molex 4 Pin to DC,4mm
945071 Adaptor Cable, Molex 4 Pin to RJ11
945072 Adaptor Cable, Molex 4 Pin to Mini DIN 6 Pin
Male
945073 Adaptor Cable, Molex 4 Pin to DC, 3.5 mm
945074 Adaptor Cable, Molex 4 Pin to Mini USB
945075 Adaptor Cable, Molex 4 Pin to PS2
945076 Adaptor Cable, Molex 4 Pin to Mini DIN 6 Pin
Female
945077 Adaptor Cable, Molex 4 Pin to RJ45
945078 Adaptor Cable, Molex 4 Pin to RX/TX/Ground
with open end wires
Trademarks are owned by the respective manufacturers. Copyright
1995-2009 C1 Group.
For information or assistance with this site, contact C1 Group
Helpdesk EAOE
Press Digital Australia - Your Mobile Computing Specialists
PDA Phones, Classic PDAs & Accessories
