X-10 Wired Lamp Receiver

The wired lamp module receives X10 commands sent on the power lines by an X10 controller.

This small unit fits almost anywhere. It can be built–in to, or wired to the device you want it to control. Add remote or automated control to any incandescent light in your home.

How it works

Your electrician will connect the wired lamp module into the 240V supply, then connect the light you want to control to the module. Set the wired lamp module's X10 address with the two dials on the front of the module and that's it...that easy!

• Turn your lights on and off no matter where you are in the house.
• Controls any 240V incandescent light up to 300W resistive load.

If you wish to maintain control of the light using a wall switch, you will need to replace your wall switch with an X10 transmitting wall switch, otherwise purchase the DIN mounted Dimmer.