X-10 Relay Receiver (micro module)

• Small enough to fit into a wall box behind a standard wall switch. Only 46x46x17 mm

• Affordable

• Works with any X10 controller

• Light can still be controlled by the original wall switch

• Now every light can be automated!

The AW 12 Micro Module can be mounted behind any standard wall switch, even most designer switches.

It is an X10 receiver module that can be controlled by any X-10 controller or remote control sending X-10 signals. The internal relay can also be tripped by external latched or momentary action wall switches.

The AW 12 responds to the standard X-10 commands like "All Units On", "All Units Off", "All Lights Off" from any X-10 controller set to its house code regardless of unit code or alternatively individual unit control by "On", "Off".

House code and unit code are programmed using any X10 compatible controller. There is an E²PROM that stores the house and unit code even when the power is cut.

• Supply voltage: 230 V +10% -15% 50 Hz

• Supply current : < 20 mA capacitive

• Making capacity: 2000 W ( incandescent lamp)
  3 A (motors)
  16 A (resistive loads)

• Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz

• Input impedance: ³180 Ohms (L - N) at 120 kHz

• Connections: screw type terminals for phase, neutral and switched phase, wire for switch connection

• Ambient temperature: - 10° C to + 40° C (operation)
  - 20° C to + 70° C (storage)

• Dimensions: 46 x 46 x 17 mm