Advanced A10 circuitry, X10
Signal Compatible
- X10 Standard Code (256 Addresses) and X10 compatible
- Two way powerline communication, reports status upon Status
Request command
- Automatically updates transmitters that have the same address
- Equipped with a 20A Form A relay
The RS214 is A10
enhanced powerline carrier switch receivers controlling a single
internal form A latching relay. It may be remote controlled specifically
by its address, or through groups by the commands ALL LIGHTS ON, ALL
LIGHTS OFF, or ALL UNITS OFF. These global commands must be configured.
When the RS214 local push-button is activated, it will
transmit the corresponding Status Reply two seconds later.
A status LED verifies power to unit, and
guides a simple configuring procedure. The LED on the face is a guide in
configuring and also indicates status and power. The RS214 can be
configured to any of the standard 256 individual X10 addresses.
Easy Push Button Configuring for Standard
Unit Address ON/OFF and:
- Setting response to "All Lights On" Command
- Setting response to "All Units On" Command
- Setting response to "All Lights Off" Command
- Enabling or disabling "Polite Mode"
- Set LED to be "ON" (direct acting) or "OFF" (reverse acting) when load
is off
Trademarks are owned by the respective manufacturers. Copyright
1995-2008 C1 Group.
For information or assistance with this site, contact C1 Group
Helpdesk EAOE
Links: Technology at
Play
Home Automation
