The DIX2 is an A-10 micro module
Transmitter that is wired behind momentary ('bell' press) switches
(4 max). The switches connected to the DIX2 effectively become A-10
Transmitters, enabling them to control your X-10/A-10 Receivers and
Interfaces. The DIX2 is similar to the DIX1 except that it controls
only two X-10 addresses. However, the DIX2 has two connections per
address, enabling one momentary switch to be used for on/bright
commands and another to be used for off/dim commands. The DIX2 works
best with 2-way momentary rocker switches as a momentary press up is
used for on/bright and a momentary press down on the same switch
sends off/dim commands. Note, the DIX2 does not directly control a
load - it is an A-10 Transmitter only.
Characteristics
Sends ON/OFF and DIM commands
Can control up to a maximum of two
addresses
Two inputs per address; one for
on/bright and another for off/dim
Can only be applied with momentary
switches
Supports status request to ensure
command reception
Operation
The wires of the DIX2 module
can be connected to momentary ('bell' press) switches. With one module,
a maximum of two addresses can be controlled by connecting it to either
one 2-way momentary switch, or two 1-way momentary switches.
Installation
instructions
Active and neutral wires are
required to be connected to the DIX2
Trademarks are owned by the respective manufacturers. Copyright
1995-2008 C1 Group.
For information or assistance with this site, contact C1 Group
Helpdesk EAOE
Links: Technology at
Play
Home Automation
